Провод для свингера Optics Light Pipe Kit

Illuminate Optics heads with a wicked pulsing glow

Use fibre optic technology to illuminate Optics Heads with a wicked pulsing glow direct from the Siren R3 alarms allowing you to match your optics to any R3 LED colour.

Light pipes gently illuminate the area around the Optics Head with a unique regenerating glow that fades in and out. Available in 12cm and 20cm

• Direct attachment into Siren R3 alarms
• Fibre Optic light transmission
• Colour matches your Optics head to your LEDs
• Unique regenerating glow
• Available in 12 and 20cm

NOTE: Optics Light Pipes replicate LED colours of R3 alarms only.

Fitting Optics Light Pipes to Siren R3s

1. Remove the Light Pipe from the blister pack. Do NOT remove the soft moulded diffuser at one end.
2. Remove the rubber grommet from the direct Optics connection socket at the front of the R3 alarm.
3. Push the end of the Light Pipe WITHOUT the soft moulded diffuser into the R3’s Optics connection socket, and carefully screw into the thread. The end of the light pipe MUST be touching the LED inside the R3.
4. Your Optics Head or Mega Head can now be screwed on to the end of the Light Pipe that has the soft moulded diffuser.

Fitting Drag Weights to Optics Light Pipes

1. Temporarily remove the moulded diffuser from the end of the Light Pipe.
2. Loosen the two sections of threaded collar at the same end of the Light Pipe by unscrewing two complete turns.
3. Push the collar down the Light Pipe by 7mm to make room for the drag weight and retighten to lock it into position.
4. To add several drag weights slide the collars further along the Light Pipe to create the additional space required. To fit two Drag Weights slide the collar 14mm, for three drag weights 21mm.
5. Slide the drag weight on and screw into the threaded collar.
6. Replace the moulded diffuser at the end of the Light Pipe. Your Optics Head or Mega Head can now be slid on and screwed to the Drag Weight.